Click here to download installation and use instructions. Requires Adobe Acrobat Reader.

Handle with care! The Wrap-A-Way has 3 cutting edges that can cut and scratch! Place masking tape over the blades prior to installation to protect you and your clothing.

Select a location for your dispenser and carefully hold it in place. Check for fit and any obstructions which may interfere with dispensing. Make sure you have room to pull wraps. All models are shipped for "right tear", but can easily be converted to "left tear" by removing the door hinges and installing on the opposite side of the unit. To reverse the towel hook (Deluxe Models), gently tap the hook to remove and then install on on opposite side of dispenser in pre-drilled holes.

NOTE: Never stain, paint, varnish or alter the the interior of the wrap compartments.

Most cabinets have a front and rear frame to which the Wrap-A-Way is attached. Hold the dispenser under the cabinet with one hand and use a sharp pencil or awl to mark the locations of the 4 mounting SLOTS for drilling. Drill 7/16" holes into the the cabinet frames to prevent splitting. Using the 4 screws provided and a screwdriver, drive each screw through the dispenser frame until tight.

When your Wrap-A-Way is successfully installed, please refer to the How to Use section of our site to learn how to use the dispenser correctly.

-- Special Considerations --

In most cases the Wrap-A-Way dispenser installs in minutes. Here are a few instances where a slight modification to the installation is necessary.

Cabinets without a rear frame will require a wood spacer (not provided) the same thickness as the front cabinet frame and the length of the dispenser.

Custom cabinets deeper than 12 inches may require the installation of a rear plate (not provided) on the dispenser to prevent wraps from sliding back.

Island cabinets are ideal for the Wrap-A-Way. Another door can be added to the dispenser if desired to permit front or rear loading of wraps. Contact us to obtain a second door.

European cabinets with full overlay doors will require installation of approximately 1/8" front and rear shims (not provided) between cabinet and dispenser to provide clearance when opening dispenser door.

Tiles, paneling or other decor applied to the wall may cause the dispenser to protrude beyond the face of the cabinet. If it is not practical to remove the decoration, trim the overlapping frame with a piece of quarter round molding (not provided). Stain or paint molding to match.

Lighting under modern cabinets may leave little room to install the dispenser. The only solution may be to remove a portion of the lighting.

DON'T GIVE UP IF YOUR WRAP-A-WAY IS NOT A TYPICAL INSTALLATION! The extra effort will be rewarded by years of enjoyment, convenience and satisfaction. Please call our Customer Service Hotline (1-866-296-0263) if you require assistance. We offer an unconditional 30-day money back guarantee! If your Wrap-A-Way can not be installed properly or if you are not completely satisfied with our product, simply call our Customer Service Hotline to arrange for return shipment and receive a complete refund.

Happy Wrapping!!